How to Reset and Configure Epson printer?
Introduction
of Epson.
Epson is a Japanese electronics company
which is one of the largest manufacturers of computers printers,and
information.
The headquartered of Epson corporation is
located in Suwa, Nagano, in Japan.
Epson
corporation is based on the electronics industry, Which was founded in 77
years ago in May 1942.
The area
served by Epson printers is Worldwide, Epson deal with information-related equipment
and electronic devices.
Company
manufactures many devices like inkjet, dot matrix and laser printers, scanners,
computers, home theatre projectors and multimedia and much more.
Epson is one of the biggest creators of
data and imaging-related hardware as well as PC printers. Different electronic
gadgets like home machines, scanners, printers, and other mechanization gear are
produced in wide range with various assortments. Fundamentally, Epson ends up
prevalent because of its printer quality just as help administrations for
specialized issues.
At the time of using Epson
printer problems may come. At the time user-facing problems related to Epson
printer do not get panic simply, contact to Epson printer support 1-833-430-6109 and get the solution immediately.
Steps to Reset and Configure Epson printer:-
Steps to Reset Epson printer:-
- At first user has to turn off the printer.
- Now use a clip to press and hold the reset which is in the back of the printer.
- User has to turn the printer on, during holding a reset button. Continue to hold the reset button.
- A warning will print out, After 5 seconds, then release the reset button.
- And after this another sheet print which shows the factory reset IP address of the printer after 5 more seconds. The newer model will default to DHCP address.
Steps to Configure Epson printer:-
- First user has to open safari, on an ipad connected to the revel network.
- Now user has to enter the printer’s ip address, then click to go.
- The next page will direct user to enter the login information
- Username: Epson
- Password: Epson
- After all this now navigate to TCP/IP in the Configuration menu.
- User has to configure the following settings.
- Now get the IP address: Manual
- Now set using automatic private IP Addressing (APIPA): Disable.
- After this set using PING: Disable.
- IP address: desired IP of the printer
- Subnet mask: 255.255.255.0
- Default Gateway: 0.0.0.0
- Socket timeout value: 300
- Now click to submit.
- Now the user has to reset, or power cycle the printer.